Motor Driven Automatic Electronic Lubricators - Electro Luber

The Electro-Luber MD 2000 is a self-contained, microprocessor controlled, motor-driven automatic lubricator. Electro-Luber is an automatic electronic lubricant dispenser giving continuous lubrication protection 24 hours per day. It cannot be termed as a pressure vessel as it is not operated by producing gas. Instead, the operation of the lubricator is dependent on the use of minor internal pressure forcing lubricant into the threads of a unique rotating auger pump. It is this that mixes and dispenses the lubricant at pressures up to 200 psi. the pressure avails the lubricator to be used not only with long feed line pipework, and it can even cycle progressive distributors allowing one MD 2000 to feed several bearings. When one or a combination of selector switches are turned on, the unit will activate at selected intervals. At each interval, approximately 1cc of grease will be delivered to the bearing. In addition it must be noted that the grease output is not affected by outside temperature or altitude.

Advantages of Using Electro Luber:

The benefits of Electro Luber can be listed as follows -

1. It involves a two method way to automatically dispense the lubricant and grease on ball bearings. Thus it fosters reusable Motor driven units and the electro-chemical cell that generates inert nitrogen gas.
2. The large variety of Electro Lube available in the market also avails great demand. It is available is 125cc (8 3/4" high x 3 1/6" diameter), 250cc (8 1/2" high x 4" diameter), and 500cc (8 1/2" high x 4 3/4" diameter) sizes.
3. The lubricator is available in both Alkaline and Lithium battery packs and is designed as single point lubricators or to feed multiple ball bearings using progressive distribution blocks from Digilube.
4. Available with a warranty of two years, the units of Electro Luber is pre filled with the lubricant of the buyers specification.
5. Electro-Luber MD units can be used underwater to depths of 60 ft. (20 meters) and the use for alkaline is only recommended up till 50 - 85 F (-10 - 30 C)

It is advised that for the successful and reliable application of the lubricator one should avoid the use of Electro Luber in case of automatic grease dispensers in temperatures below 14 F (10 C), above 170 F (76 C), or in an application requiring more than 200 psi. Installing the Electro Luber MD (units have 1/2" NPT threads and come with a brass adapter) directly on the bearing is the best way to install this lubricator. Even after the filling is empty, refilling can be easily accomplished by using a standard grease gun.

Electro-Luber
and Lubricants Manufacturers & Suppliers.

Camera Review
Linda Story Blog
Wade Photo Tips